Here is what you will be doing: We are looking to fill the position of a Senior Electrical Engineer to join our electrical engineering unit, forming part of a multi-disciplinary consulting engineering team. Primary responsibilities will include the following: Preparation and management of schedules, estimates, progress reports, meetings, procurement etc. Electrical engineering and design during all project phases according to client, national and international standards. Assessing of Client / Project Electrical Engineering Requirements. Prepare concept design and the ability to objectively evaluate both technically and commercially, different options based upon project objectives / requirements. Cost Estimation of electrical Engineering scope of work, including equipment and construction costs. Detailed Electrical Engineering of LV and MV (up to 132kV) including the development and checking of : o Load Lists o Single Line Diagrams o Network Diagrams o Electrical Schematic Diagrams o Hazardous Area Classification o Diversification and Load factors. o Electrical Network Design o Fault Level Calculations o Motor start-up and Protection Schemes (MV and LV) o Protection Schemes modelling of protection schemes and definition of Protection settings. o CT Specification. o Power Metering specification and interface to Energy / Building Management Systems. o Cable Routing Design o Cable Sizing Calculations o Lighting Calculations, modelling and layouts. o Earthing Risk Assessments, earthing system design, Earthing layouts. o Specification of Electrical Equipment including, Switchgear, Distribution Boards, Motor Control Centres, Transformers, Motors, VSD’s, Soft starters, UPS’s, Power Factor Correction, Filters, Cables, Lighting, BMS and communication systems. o Fire detection Systems layouts and Specification. o Specification of Construction Standards of installation. Interface with PLC’s, DCS systems and Building Management Systems and design the interface Control Systems. Interface with Energy Efficiency and providing energy efficient electrical solutions. Interface and Familiar with Quality of Power Supply requirements and evaluation. Design schemes to reduce Electromagnetic interference and specify EMC requirements. Design and specify communications systems with Electrical equipment / systems including Serial Communications using Profibus / fieldbus, Ethernet etc. Perform and check system studies (e.g. short circuit; load flow and protection coordination). Utilise vendor data and work with other disciplines as required for engineering and design. Participate and Perform squad checks of vendor data and drawings from other disciplines. Develop and check equipment purchase specification and develop RFQ’s (e.g. MV and LV switchboards; D/B.s, MCC’s, power transformers, Power factor Correction motors, VSDs, UPSs Filters, Cables, Lighting, BMS and communication systems). Develop technical scope of work and tender documentation and bills of quantities for construction contracts. Develop tender documentation, adjudicate tenders, provide re-measurement of works and approve contract claims. Prepare Project Scheduling and Planning, developing basic Barcharts for Electrical Engineering input to project management team. Manage progress & quality control activities for equipment manufacture. Conduct vendor inspections and factory acceptance testing of equipment. Manage switchgear and specialist equipment contractors. Provide field engineering support to construction and commissioning teams.Project handover and closeout documentation. Provide guidance and mentorship to less experienced engineers. Assist in the setting up of standard engineering documentation and methodology for the electrical engineering unit. Develop Client relations and extend the client base. Assist in the preparation of tenders for Electrical unit workload.
Here is what we are looking for: BEng/BSc Electrical engineering Over 8 years experience as an engineer within the built environment Professionally registered as an Engineer with ECSA or equivalent Sound electrical engineering knowledge and experience in LV and MV (up to 132kV) environment An intimate knowledge of local standards and codes. Be able to develop engineering documentation from first principles. Be able to work within a disciplined engineering environment. Conversant with ETAP (or other equivalent package) electrical power systems modelling and analysis software. An intimate working knowledge of Microsoft Office, including Excel, Word, Access and Microsoft Project. Experience with Green Building Design and accreditation. Be well acquainted with local equipment, manufacturers, suppliers and installation contractors. A thorough knowledge of the OHS Act, pertinent SANS and IEC codes and standards and industry practices. Good communication and people management skills for effective interface with other engineering disciplines, the client and contractors. The ability to work independently. An awar